HP StorageWorks M2402 User Manual page 69

Visual Manager User Interface
Note: If Server-Free Backup Mode is enabled, Fibre Channel Discovery must be
enabled to allow router access to Fibre Channel Targets.
For information on controller LUN and Extended Copy commands, see
Appendix B, "The HP StorageWorks Network Storage Router M2402 supports
and executes the set of SCSI-3 commands listed in this Appendix. These
commands can be received as FCP commands over the FC bus and are supported
by the Controller LUNs. This document refers to these commands as Controller
LUN commands. Complete definitions of SCSI-3 commands can be found in the
SCSI-3 standard available from the American National Standards Institute
(ANSI).."
For general information about server-free backups, see Chapter 1, "Introduction."
Network Storage Router M2402 User Guide 75