Verifying Scsi Devices In Windows Nt - HP StorageWorks M2402 User Manual

One method of verifying link integrity when connected to a functional host,
involves disconnecting and then reconnecting the FC cable. This procedure
should cause momentary activity of this indicator as the link reinitializes.
Additionally, verify that the media type of the router and the attached hub, HBA,
or switch is of corresponding types. When using optical media, verify that the
attached device is using non-OFC type optical devices.

Verifying SCSI Devices in Windows NT

If running FC-to-SCSI mapping mode, verify the FC and the SCSI devices are
recognized by the router.
Sometimes Windows NT may need to be rebooted with all SCSI devices and the
router powered up before recognizing the devices.
Verify the FC and the SCSI devices:
Verifying the Router Configuration
If you are in doubt about the configuration or about the location of the error,
restore the router to the factory default configuration and proceed to configure the
unit one step at a time, verifying the functionality of the configuration after each
change is made.
Network Storage Router M2402 User Guide
To verify the FC devices, navigate to the Windows NT Control Panel, select
SCSI Adapters, and double click the FC HBA.
The SCSI devices should be listed.
If no devices are listed, verify the router configuration, FC HBA
configuration, and cabling.
If devices are listed, verify the FC HBA mapping mode or the AL_PA
addresses.
To verify the SCSI devices, navigate to the Windows NT Control Panel,
select SCSI adapters, and double click the SCSI controller.
If no devices are listed, verify the router configuration, SCSI Controller
configuration, and cabling.
Caution: Restoring factory defaults overwrites user configurations. In the
serial/ Telnet interface, use the save configuration option before resetting
factory defaults, to allow recovery of user configuration.
Basic Troubleshooting
203