HP StorageWorks M2402 User Manual page 82

Visual Manager User Interface
SCSI module bus settings:
Note:
Note:
use Fibre Channel devices. This type of configuration is known as a Target Mode
configuration.
Note:
complete their individual power-ups.
88
Primary Initiator ID (default: 7) must be a unique ID.
Alternate Initiator ID (default: none) will be used if the primary ID is taken.
Must be a unique ID.
Caution: If this configuration setting is incorrectly set, processing difficulties
may occur. Before changing this setting, evaluate the need for the change and
verify the desired setting. HP recommends backing up the router configuration
to an external file before making changes to this setting.
Target ID(s) adds or removes Target IDs.
Caution: If this configuration setting is incorrectly set, processing difficulties
may occur. Before changing this setting, evaluate the need for the change and
verify the desired setting. HP recommends backing up the router configuration
to an external file before making changes to this setting.
Target IDs must be set up prior to mapping devices on the SCSI bus.
Do not enable Target IDs unless there is a SCSI initiator on the bus that wants to
Discovery toggles between Enabled and Disabled.
Discovery Delay is the wait time after a power-up or reboot before
discovering SCSI devices.
HP recommends setting the value to at least 2 seconds to ensure all SCSI devices
Network Storage Router M2402 User Guide