Parts Identification - Optex HX-40 Installation Instructions Manual

-Precautions for installing two or more sensors
Do not install two or more HX-40DAM's units side-by-side or face-to-face. Instead, install them
back-to-back. If mounting on the same wall, be sure they are at least 1.0 m (3'3") apart from
each other.
1.0 m (3'3") or more
1-2

PARTS IDENTIFICATION

Bracket base
Bracket
Shaft cover
Lock screw* (M4 × 35 mm)
Screw (4 × 20 mm)
Screw kit
For joint
Screw (4 × 20 mm)
*Lock screw attached on bracket base
HX-40DAM_EN.indd 3 HX-40DAM_EN.indd 3
Less than 1.0 m (3'3")
Base
Terminals
Microwave unit
(HX-40DAM only)
(Do not touch)
LED indicator
For wall mounting For hood
Screw (4 × 20 mm) Screw (3 × 10 mm)
- 3 -
Screw (3 × 10 mm)
Main unit
PIR sensor
(Do not touch)
Anti-masking infrared LED
(HX-40AM/DAM only)
Area masking seal
HX-40
HX-40AM
HX-40DAM
Hood
Lens
Cover
Lock screw
2010/06/24 14:11:58 2010/06/24 14:11:58