Optex HX-40 Installation Instructions Manual page 7

Determine the horizontal direction (left or
5
right) of the detector before installing the
bracket on the wall.
To the right
Open the Up-Down lock screw knockout
7
for connecting the bracket.
Knockout with 4 × 20
tapping screw (screwkit)
Tighten the adjustment screw clockwise.
9
Adjustment
screw
Install the shaft cover into place.
11
HX-40DAM_EN.indd 7 HX-40DAM_EN.indd 7
Open the wiring knockout.
6
To the left
Tighten screws 1 and 2, adjust the bracket
8
angle (refer to 2-2), then tighten screw 3.
Perform an area check. If re-adjustment is
required, loosen screw 3 and change the
bracket angle.
After the adjustment is complete, tighten
screw 3 again.
In
Wiring
Wiring
hole
sponge pad
Wire to the terminal and install the main
10
unit and lens on the base.
- 7 -
Wiring knockout
14 × 20 screw
Out
34 × 35 Up-Down
lock screw
24 × 20 screw
2010/06/24 14:12:00 2010/06/24 14:12:00