Installation; Mounting With Bracket - Optex HX-40 Installation Instructions Manual

2

INSTALLATION

Use the bracket for normal installation. The unit may be mounted directly on the wall, without
the bracket, only if the following three conditions are not;
• The mounting height 3.0 m (9'10").
• Horizontal direction adjustment is unnecessary.
• The ground is level.
2-1

MOUNTING WITH BRACKET

Using the bracket makes it possible to adjust the unit horizontally by ±90°.
In cases where the ground is uneven and/or not parallel with the base of the unit, it is possible
to adjust the unit vertically by ±20°.
90°
Remove the Up-Down lock screw.
1
Loosen the adjustment screw two turns.
3
Adjustment screw
Caution>>
Do not loosen the
screw too much.
It may disassemble.
HX-40DAM_EN.indd 6 HX-40DAM_EN.indd 6
90°
20°
20°
Push the shaft cover clip straightforwardly with
2
your thumb. In case the clip is stuck, use a
suitable tool. e.g. back side of a screw driver.
Tilt the bracket about 45° and pass
4
through the wire.
In
- 6 -
Caution>>
Do not change the detection
length with bracket.
Use the masking seal to
adjust the detection length.
Shaft cover
Shaft cover clip
Out
2010/06/24 14:11:59 2010/06/24 14:11:59