Software Update - Docomo arrows tab lte F-01D Instruction Manual

Software update

This function allows you to connect the network and
check if software in the F-01D needs to be updated, if
software update is necessary, download a part of
software using packet communication and update the
software.
Check the NTT DOCOMO website to see if software
updates are necessary.
･
Software may be updated in following 3 methods :
Auto-update : New software can be downloaded
automatically and rewritten at a preset time.
Now update : Software is updated immediately.
Reserve update : Software is updated automatically at
the preset time if you reserve the time to install update
packages.
✔INFORMATION
･
Software update can be done even when various data,
such as contacts registered in the terminal, camera
images, mail, downloaded data, are remaining; note that
data protection sometimes cannot be secured according
to the conditions of your F-01D (such as malfunction,
damage, or water leak). DOCOMO recommends backing
up necessary data. However some data such as
downloaded data may not be backed up.
◆ When updating software
･
Software update should be done with battery fully
charged.
･
Software cannot be updated in the following cases.
- When 圏外 (out of service area) is displayed
- During international roaming
- When Airplane mode is on
- While upgrading the operating system
- When date and time are not set correctly
- When the remaining battery is not sufficient for
software update
- When the remaining memory is not sufficient for
software update
･
Software update (downloading or rewriting) may take
time.
･
Communications functions and other functions are
disabled during software update.
･
During a software update, the terminal performs SSL/
TLS communications with the server (DOCOMO site).
･
It is recommended that software update be executed in
good radio wave conditions with four bars of the signal
status icon displayed and the terminal not moved. If
radio wave conditions become weaker during software
download and the download is stopped, retry software
update in a place with strong radio wave conditions.
･
If software has already been updated, [No update is
needed.] appears when software updated is checked.
･
During international roaming or when the terminal is out
of service area, [Failed to start update. Due to no
network or roaming.] appears.
･
If there is insufficient battery power for a software
update, [Failed to start update. Due to low battery.
Please recharge and retry later.] or [Failed to start
rewriting. Please recharge and retry later.] appears.
･
SMS sent during software update is stored in the SMS
center.
･
When updating software, your private information
concerning F-01D (model, serial number, etc.) is
automatically sent to the server (the server for software
update managed by DOCOMO). DOCOMO does not use
the sent information for purposes except software
update.
･
When software update has failed, [Rewrite failed]
appears and all operation may become unavailable. In
that case, please bring the terminal to DOCOMO-
specified repair office.
･
When PIN code is set, the PIN code entry screen appears
during resetting after rewriting and you need to enter
PIN code.
･
While updating software, do not activate other
applications.
106
Appendix/Index