Cpu Installation And Upgrading; Install A Cpu In The Zif Socket - Advantech PCM-5862E User Manual

CPU installation and upgrading

You can upgrade to a higher power Pentium processor at any time.
Simply remove the old CPU, install the new one, and set the
jumpers for the new CPU type and speed.
Warning! Always disconnect the power cord from your
Caution! Always ground yourself to remove any static

Install a CPU in the ZIF socket

PCM-5862E/5862EL provides a Zero Insertion Force (ZIF) socket
for easy CPU installation.
1. Make sure the ZIF socket lever is in the upright position. To
raise the lever, pull it out to the side a little and raise it as far as
it will go.
2. Place the CPU in the empty socket. Follow the instructions that
came with the CPU. If you have no instructions, do the
following: Carefully align the CPU so it is parallel to the socket
and the notch on the corner of the CPU corresponds with the
notch on the inside of the socket. Gently slide the CPU in. It
should insert easily. If it doesn't, pull the lever up a little more.
chassis when you are working on it. Do not make
connections while the power is on as sensitive
electronic components can be damaged by the
sudden rush of power. Only experienced
electronics personnel should open the PC chassis.
charge before touching the PC board. Modern
electronic devices are very sensitive to static
electric charges. Use a grounding wrist strap at
all times. Place all electronic components on a
static-dissipative surface or in a static-shielded
bag when they are not in the chassis.
Chapter 2 Installation 13