Table of Contents
Advertisement
Introduction
The PCM-5862E/EL is equipped with a high performance 32-bit Ethernet
chipset which is fully compliant with IEEE 802.3 100 Mbps CSMA/CD
standards. It is supported by major network operating systems. It is also
both 100Base-T and 10Base-T compatible. The medium type can be
configured via the RSET8139.exe program included on the utility disk.
The Ethernet port provides a standard RJ-45 jack which is available as an
optional cable kit. The network boot feature can be utilized by incorporat-
ing the boot ROM image files for the appropriate network operating
system. The boot ROM BIOS files are combined with system BIOS,
which can be enabled/disabled in the BIOS setup.
Installation of Ethernet Driver
Before installing the Ethernet driver, note the procedures below. You must
know which operating system you are using in your PCM-5862E/EL, and
then refer to the corresponding installation flow chart. Then just follow the
steps described in the flow chart. You will quickly and successfully
complete the installation, even if you are not familiar with instructions for
MS-DOS or WINDOWS.
Note 1:
Installation for MS-DOS & WINDOWS 3.1
If you want to set up your Ethernet connection under the MS-DOS or
Windows 3.1 environment, you should first check your server system
model. For example, MS-NT, IBM-LAN server, and so on.
Then choose the correct driver to install in your panel PC.
The installation procedures for various servers can be found on the disk
labled: "RTL 8139A Driver #2".
72
PPC-120/140 User's Manual
The windows illustrations in this chapter are examples
only. You must follow the flow chart instructions and pay
attention to the instructions which then appear on your
screen.
Advertisement
Table of Contents
