Configuring Lldpdu Tlvs - H3C S5120-EI Series Operation Manual

Configuring LLDPDU TLVs

Follow these steps to configure LLDPDU TLVs:
To do...
Enter system view
Set the TTL multiplier
Enter
Ethernet
interface
view/port
group view
Enable LLDP TLV sending
for specific types of LLDP
TLVs
Specify the management
address and specify to
send the management
address through LLDPDUs
Use the command...
system-view
lldp hold-multiplier value
Enter
Ethernet interface interface-type
interface interface-number
view
Enter port port-group manual
group view port-group-name
lldp tlv-enable { basic-tlv { all |
port-description |
system-capability |
system-description |
system-name } | dot1-tlv { all |
port-vlan-id | protocol-vlan-id
[ vlan-id ] | vlan-name [ vlan-id ] } |
dot3-tlv { all | link-aggregation |
mac-physic | max-frame-size |
power } | med-tlv { all | capability |
inventory | location-id
{ civic-address device-type
country-code { ca-type
ca-value }&<1–10> | elin-address
tel-number } | network-policy |
power-over-ethernet } }
lldp management-address-tlv
[ ip-address ]
—
Optional
4 by default.
Either of the two is required.
Configuration performed in
Ethernet interface view applies
to the current port only;
configuration performed in port
group view applies to all the
ports in the corresponding port
group.
Optional
By default, all types of LLDP
TLVs except location
identification TLV are sent.
Optional
By default, the management
address is sent through
LLDPDUs, and the
management address is the IP
address of the interface of the
VLAN with the least VLAN ID
among those permitted on the
port. If the IP address of the
VLAN interface is not
configured, IP address
127.0.0.1 is used as the
management address. Refer to
VLAN Configuration in the
Access Volume for information
about VLAN.
1-6
Remarks