H3C S5120-EI Series Operation Manual page 436

Configuration procedure
1) Configuring IP addresses for interfaces (omitted)
2) Configuring static routes
# Configure a default route on Switch A.
<SwitchA> system-view
[SwitchA] ip route-static 0.0.0.0 0.0.0.0 1.1.4.2
# Configure two static routes on Switch B.
<SwitchB> system-view
[SwitchB] ip route-static 1.1.2.0 255.255.255.0 1.1.4.1
[SwitchB] ip route-static 1.1.3.0 255.255.255.0 1.1.5.6
# Configure a default route on Switch C
<SwitchC> system-view
[SwitchC] ip route-static 0.0.0.0 0.0.0.0 1.1.5.5
3) Configure the hosts.
The default gateways for the three hosts A, B and C are 1.1.2.3, 1.1.6.1 and 1.1.3.1 respectively. The
configuration procedure is omitted.
4) Display the configuration.
# Display the IP routing table of Switch A.
[SwitchA] display ip routing-table
Routing Tables: Public
Destinations : 7
Destination/Mask
0.0.0.0/0
1.1.2.0/24
1.1.2.3/32
1.1.4.0/30
1.1.4.1/32
127.0.0.0/8
127.0.0.1/32
# Display the IP routing table of Switch B.
[SwitchB] display ip routing-table
Routing Tables: Public
Destinations : 10
Destination/Mask
1.1.2.0/24
1.1.3.0/24
1.1.4.0/30
1.1.4.2/32
1.1.5.4/30
1.1.5.5/32
Routes : 7
Proto Pre Cost
Static 60 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Routes : 10
Proto Pre Cost
Static 60 0
Static 60 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
1-5
NextHop Interface
1.1.4.2 Vlan500
1.1.2.3 Vlan300
127.0.0.1 InLoop0
1.1.4.1 Vlan500
127.0.0.1 InLoop0
127.0.0.1 InLoop0
127.0.0.1 InLoop0
NextHop Interface
1.1.4.1 Vlan500
1.1.5.6 Vlan600
1.1.4.2 Vlan500
127.0.0.1 InLoop0
1.1.5.5 Vlan600
127.0.0.1 InLoop0