Brother FAX-2840 Service Manual page 229

WSW No.
WSW72 Reserved (Change of the setting is prohibited)
WSW73 Reserved (Change of the setting is prohibited)
WSW74 ADF stop control
WSW75 Paper ejecting distance of the switch back
The limited number of the documents in reverse for paper ejection of the
WSW76
simplex scanning from ADF
The limited number of the documents in reverse for paper ejection of the
WSW77
duplex scanning from ADF
WSW78 Recording stop function when the drum reaches the end of life
* Refer to the separate manual for details of worker switches.
<Operating Procedure>
(1) Press the [1] and [0] buttons in this order in the initial state of the maintenance mode.
"WSW00" appears on the LCD, indicating that the machine is ready to accept worker
switch number entry.
(2) Enter the desired number from the worker switch numbers (01 through 78). The
following display appears on the LCD.
Selector 1
WSWXX = 0 0 0 0 0 0 0 0
(3) Enter a value to be set (0 or 1) using the [0] and [1] buttons.
(4) Press the [OK] button. The new selector values are saved in the EEPROM, and the LCD
returns to the ready state for worker switch number entry.
(5) Repeat steps (2) through (4) until the modification for the desired worker switches is
completed.
(6) When the [Stop/Exit] button is pressed, the machine beeps for one second and returns
to the initial state of the maintenance mode.
Note:
• To cancel the operation and return the machine to the initial state of the maintenance
mode during the above procedure, press the [Stop/Exit] button.
• If there is a pause of more than one minute after a single-digit number is entered for
double-digit worker switch numbers, the machine will automatically return to the initial
state of the maintenance mode.
Function
Selector 8
5-10
Confidential