Brother FAX-2840 Service Manual page 181

(4) Remove the screw pan (S/P washer) M3.5x6 screw to remove the earth harness from
the low voltage power supply PCB ASSY.
(5) Remove the taptite flat B M3x10 screw to remove the inlet of the low voltage power
supply PCB ASSY.
(6) Release the two hooks, and remove the power supply switch of the low voltage power
supply PCB ASSY.
(7) Remove the taptite bind B M4x12 screw.
(8) Release the harness of the low voltage power supply PCB ASSY from the guide on the
main frame R ASSY.
Main frame R ASSY
Low voltage power
supply PCB ASSY
Taptite bind B M4x12
Screw pan (S/P washer) M3.5x6
Assembling Note :
• Attach the inlet as shown in the figure below.
Earth harness
Hook
Power supply
switch
Fig. 3-45
2
Inlet
1
Fig. 3-46
3-57
Harness of
low voltage power
supply PCB ASSY
Taptite flat B M3x10
Inlet
Hook
Guide
Confidential