Brother FAX-2840 Service Manual page 59

Code 1 Code 2
Polled by any other manufacturers' terminal while waiting
40 13
for secure polling.
40 14 Common key not registered although it needs to be used.
40 17 Invalid resolution selected.
63 02 Password not correct.
63 03 Polling ID not correct.
74 XX DCN received.
80 01 Fallback impossible.
Unable to detect video signals or commands within 6
90 01
seconds after CFR is transmitted.
Received PPS containing invalid page count or block
90 02
count.
Error correction sequence not terminated even at the final
A0 03
transmission speed for fallback.
A0 11 Receive buffer empty (5-second time-out).
Receive buffer full during operation except receiving into
A0 12
memory.
A0 13 Decoding error continued on 500 lines or more.
A0 14 Decoding error continued for 15 seconds or more.
A0 15 Time-out: 13 seconds or more for one-line transmission.
A0 16 RTC not found or carrier OFF detected for 6 seconds.
RTC found but no command detected for 60 seconds or
A0 17
more.
A0 19 No video data to be sent.
A8 01 RTN, PIN, or ERR received (sending terminal).
A9 01 RTN, PIN, or ERR sent (receiving terminal).
AA 18 Receive buffer full during receiving into memory.
B0 01 Polarity reversion detected.
B0 02 Unable to receive the next-page data.
B0 04 PC interface error.
C0 01 No common modulation mode or failed to poll.
C0 02 Unable to detect JM.
C0 03 Unable to detect CM.
C0 04 Unable to detect CJ.
C0 10 Cannot finish V. 34 negotiation or training.
C0 11 Modem error detected during V. 34 negotiation or training.
C0 20 Modem error detected during sending of commands.
C0 21 Modem error detected during receiving of commands.
C0 22 Control channel connection time-out.
C0 30 Modem error detected during sending of video signals.
Cause
2-22
Refer
to:
2-82
2-82
2-82
2-82
2-82
2-82
2-82
2-82
2-82
2-82
2-82
2-82
2-82
2-82
2-82
2-82
2-82
2-82
2-82
2-82
2-82
2-82
2-82
2-82
2-82
2-82
2-82
2-82
2-82
2-82
2-82
2-82
2-82
2-82
Confidential