Remove the DIMM.
9.
To replace the component, reverse the removal procedure.
Heatsink
To remove the component:
Power down the server (on page 24).
1.
Unlock the front bezel (on page 25).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Place the server on its side.
4.
Remove the access panel
5.
If installed, remove the PCI air baffle
6.
Remove the system air baffle
7.
Remove the heatsink:
8.
Loosen one pair of diagonally opposite screws halfway, and then loosen the other pair of screws.
a.
Completely loosen all screws in the same sequence.
b.
Remove the heatsink from the processor backplate.
9.
("Access
panel" on page 26).
("PCI air
baffle" on page 27).
("System air
baffle" on page 28).
Removal and replacement procedures 43