Checking The Edit Points - Panasonic DVCPRO50 AJ-D960EG Operating Instructions Manual

Automatic editing

Checking the edit points

1
2
3
Calculating the duration
• When both edit points have been set, the duration between the two edit points.
• When only one edit point has been set, the duration between the set data and the current
tape address.
• When neither edit point has been set, the duration of the previously edited interval.
Press the IN (or OUT) button to check the edit point.
The value of the entered edit point appears on the display.
Press the PREROLL button while holding down the IN (or OUT) button to check the
image at the edit point.
The tape is cued at the edit IN (or OUT) point, and the still picture mode at that point is
displayed.
• The EE mode is established if the TAPE/EE switch has been set to the "EE" position
when "STOP" has been selected for the setup menu No. 315 (AFTER CUE-UP).
Continue to hold the IN and OUT buttons down together, and check the edit section
(duration time).
The duration time appears on the display.
ON
OFF
POWER
METER
FULL/FINE
L
MONITOR SELECT
R
LEVEL CH1 CH2 CH3 CH4
HEADPHONES
PULL
OPEN PULL FOR VARIABLE
INPUT SELECT
VIDEO Y PB PR CMPST SDTI(V&A) SDI
AUDIO ANALOG AES/EBU USER SET SDI
CH CONDITION
TC SET
SHIFT ADJ START
DVCPRO SCH CF
W
ASMBL VIDEO CH1 CH2 CH3 CH4 CUE TC
CUE
1 2 3 4 5 6 7 8
INSERT
MULTI CUE
REC PREVIEW A
AUTO EDIT
REVIEW IN – +
PREROLL TRIM
IN SET OUT
PB
2 1, 3
36 (E)
TC MODE CONTROL
TC INT TAPE REMOTE PUSH
JOG
TC/CTL
REV
UB EXT EE LOCAL
STAND BY PLAYER RECORDER
RESET
SERVO REC INHIBIT
EDIT PLAY REC
A
OUT
REW STOP FF
SLOW MOTION
EJECT
AUTO OFF
SHTL
SLOW
FWD
PULL
OPEN