Checking The Edit Points - Panasonic AJ-HD150 Operating Instructions Manual

Automatic editing

Checking the edit points

1
2
3
Calculating the duration
•
When both edit points have been set, the duration between the two edit points.
•
When only one edit point has been set, the duration between the set data and the current
tape address.
•
When neither edit point has been set, the duration of the previously edited interval.
Press the IN (or OUT) button to check the edit point.
The value of the entered edit point appears on the display.
Press the PREROLL button while holding down the IN (or OUT) button to check the
image at the edit point.
The tape is cued at the edit IN (or OUT) point, and the still picture mode at that point is
displayed.
•
The EE mode is established if the TAPE/EE switch has been set to the "EE" position
when "STOP" has been selected for the setup menu No. 307 (AFTER CUE-UP).
Press the IN and OUT buttons together to check the edit duration.
The duration time appears on the display.
ON
OFF
CH CONDITION
POWER
METER
FULL/FINE
L
MONITOR SELECT
R
LEVEL
CH 1/5 CH 2/6 CH 3/7 CH 4/8 CUE
HEADPHONES
PULL
OPEN
PULL FOR VARIABLE
ENTER ESCAPE SHIFT
RESET
TC/CTL
TC SET
AUDIO CH SELECT
SHIFT ADJ START
1 4 5 8
CH CH CH CH
ASMBL VIDEO CH1/5 CH2/8 CH3/7 CH4/8 CUE TC
1 2 3 4 5 6 7 8
INSERT
MULTICUE
REC A A
PREVIEW
AUTO EDIT
IN OUT
PREROLL
REVIEW
TRIM
IN SET OUT
PB
2 1, 3
– 39 –
M-cassette / ADAPTER
Caution: Do not insert S-cassette without adapter
TC MODE CONTROL
PUSH
TC INT TAPE REMOTE
JOG SHTL
SLOW
REV
UB EXT EE LOCAL
STAND BY PLAYER RECORDER
SERVO REC INHIBIT
EDIT PLAY REC
REW STOP FF
EJECT
FWD
PULL
OPEN