Video Output Signals And Servo Reference Signal - Panasonic DVCPRO50 AJ-D960EG Operating Instructions Manual

Video output signals and servo reference signal

This section explains how the output signals and servo reference signal are selected.
External synchronization of video output signals
The video output signals are output in synchronization with the REF VIDEO input signal or
video input signal.
As shown in the figure below, this signal is selected in accordance with the setup menu
settings, VTR mode and availability of the video input signal.
EXT
Internal synchronization
<Notes>
Synchronization is determined as follows depending on the availability of the REF VIDEO input
signal when "BB" or "CB" has been selected as the setup menu No. 600 (INT SG) setting.
• When the REF VIDEO input signal is available: Synchronization with the REF VIDEO input
signal
• When the REF VIDEO input signal is not available: Internal synchronization
Start
What is the setup
INPUT
menu No. 304 (SERVO
REF) setting?
AUTO
YES
Is the unit in one of
the editing modes?
NO
YES
Has the unit been set to
the recording mode?
NO
YES
Is the REF VIDEO
input signal available?
NO
Synchronization with the
REF VIDEO input signal
N-VF
menu No. 601 (OUT VSYNC)
NO
Is the REF VIDEO
input signal available?
YES
NO
Is the video input signal
NON-STD
menu No. 303 (STD/NON-
NON-STD
signal a standard or non-
Synchronization with
the video input signal
94 (E)
Is the video input
signal available?
YES
What is the setup
setting?
VF
Is the video input
signal available?
YES
NO
a composite signal?
YES
What is the setup
STD
STD) setting?
AUTO
Is the video input
standard signal?
STD
NO