Panasonic DVCPRO50 AJ-D960EG Operating Instructions Manual page 66

Setup menus
USER menu
<OPERATION>
No.
111
112
113
114
115
The underline on the setting item denotes the initial setting.
(continued)
Item Setting
Superimposed Superimposed
No.
display display
FRZ MODE 0000
SEL 0001 STBOFF
0002 SOF&EJ
V IN SEL 0000
INH 0001
0002
A IN SEL 0000
INH 0001
0002
REC INH 0000
LAMP 0001
EJECT SW 0000
INH 0001
66 (E)
DIS This selects the output picture in the STANDBY OFF (HALF
LOADING) and EJECT modes.
0: The video output is muted.
1: When the STANDBY OFF (HALF LOADING) mode is
established, the picture being played back at the time is
frozen and output.
2: When the STANDBY OFF (HALF LOADING) or EJECT
mode is established, the picture being played back at the
time is frozen and output.
<Notes>
• Field freeze is used for freezing the picture.
• In the EJECT mode, freeze frames are output only when 2
(BLACK), 3 (BLACK1), 4 (GRAY) or 5 (GRAY1) is selected
as the setup menu item No. 105 (AUTO EE SEL) setting.
OFF This selects whether video input switching using the INPUT
SELECT switch is to be enabled or disabled.
ON
0: Video input switching using the INPUT SELECT switch is
REC
enabled.
1: Video input switching using the INPUT SELECT switch is
disabled.
2: Video input switching using the INPUT SELECT switch
after the unit has been transferred to a recording (but not
editing) mode is disabled.
<Note>
Even when the 1 (ON) or 2 (REC) setting is selected to
disable video input switching using the INPUT SELECT
switch, it is still possible to set the setup menu item No. 600
(INT SG).
OFF This selects whether audio input switching using the INPUT
SELECT switch is to be enabled or disabled.
ON
0: Audio input switching using the INPUT SELECT switch is
REC
enabled.
1: Audio input switching using the INPUT SELECT switch is
disabled.
2: Audio input switching using the INPUT SELECT switch
after the unit has been transferred to a recording (but not
editing) mode is disabled.
<Note>
Even when the 1 (ON) or 2 (REC) setting is selected to
disable audio input switching using the INPUT SELECT
switch, it is still possible to set the setup menu items No. 700
(INT SG), No. 715 (CH1 IN SEL), No. 716 (CH2 IN SEL), No.
717 (CH3 IN SEL), No. 718 (CH4 IN SEL), No. 719 (DIGI IN
SEL12) and No. 720 (DIGI IN SEL34).
LIGHT This selects whether to cause the REC INHIBIT lamp to flash
or light up when the cassette has been set to the accidental
FLASH
erasure prevention status.
0: The lamp lights up.
1: The lamp flashes.
<Note>
When the REC INHIBIT switch is set to ON, the REC INHIBIT
lamp always lights regardless of the general setting status.
REC This selects whether to enable or disable the operation of the
EJECT button on the front panel.
OFF
0: Operation is disabled while the unit is in the recording
mode.
1: Operation is enabled in all modes.
Description