Mounting The Device On A Din Rail; Mounting The Device To A Panel - Siemens RUGGEDCOM RSG2488 Installation Manual

RUGGEDCOM RUGGEDCOM RSG2488
Installation Guide
Section 2.1.2

Mounting the Device on a DIN Rail

For DIN rail installations, the RSG2488 can be ordered with panel/DIN rail adapters pre-installed on each side of
the chassis. The adapters allow the device to be slid onto a standard 35 mm (1.4 in) DIN rail.
To mount the device to a DIN rail, do the following:
1. Align the adapters with the DIN rails and slide the device into place.
1
2
Figure 5: DIN Rail Mounting
1. DIN Rail 2. Panel/DIN Rail Adaptor
2. Install one of the supplied screws on either side of the device to secure the adapters to the DIN rails.
Section 2.1.3

Mounting the Device to a Panel

For panel installations, the RSG2488 can be ordered with panel/DIN rail adapters pre-installed on each side of
the chassis. The adapters allow the device to be attached to a panel using screws.
To mount the device to a panel, do the following:
1. Place the device against the panel and align the adapters with the mounting holes.
Mounting the Device on a DIN Rail
3
1
2
3. Screw
Chapter 2
Installing the Device
9