Connecting To The Device - Siemens RUGGEDCOM RSG2488 Installation Manual

RUGGEDCOM RUGGEDCOM RSG2488
Installation Guide
CAUTION!
Configuration hazard – risk of data loss. The microSD card must not be removed or replaced during
normal operation of the device. Make sure the device is powered down before removing or inserting
the card.
CAUTION!
Mechanical/electrical hazard – risk of damage to the microSD card.
• Do not expose the microSD car to extreme temperatures or humidity.
• Do not expose the microSD card to large magnetic or static electric fields.
• Do not bend or drop the microSD card.
CAUTION!
Security hazard – risk of unauthorized access and/or exploitation. Make sure to remove the microSD
card before decommissioning the device or sending the device to a third-party.
To insert or remove a microSD card, do the following:
1. Power down the device.
2. Unscrew the retention screws and remove the access plate.
Figure 19: Inserting/Removing a MicroSD Card
1. Access Plate
3. Without touching the contacts on the card, insert or remove the microSD card.
4. Install the access plate and finger-tighten the retention screws.
5. Power up the device.
Section 2.7

Connecting to the Device

The following describes the various methods for accessing the ROS console and Web interfaces on the device.
For more detailed instructions, refer to the ROS User Guide for the RSG2488.
Serial Console and Management Ports
Connect a workstation directly to the serial console or management ports to access the boot-time control and
ROS interfaces. The serial console port provides access to ROS 's console interface, while the management port
provides access to ROS's console and Web interfaces.
Connecting to the Device
1
2. MicroSD Card
2
Chapter 2
Installing the Device
21