2. Functions in each area
2-1-8. Rear panel connections area
TALLY/GPI input/output connector [TALLY/GPI] (D-sub 25-pin, female, inch screw)
For details on how to connect this connector, refer to "6. External interfaces".
MAIN FRAME connector [MAIN FRAME] (RJ-45) (100 Base-TX)
Connect this to the mainframe using the supplied CAT5E cable (STP, straight, 10 m).
DC power input sockets [12V
Connect the supplied AC adapters (for the control panel) to these sockets.
Ground connector [SIGNAL GND]
Connect to the system's earth ground.
Power switch [POWER]
This is used to turn the power on and off.
SERVICE switch [NORMAL/SERVICE]
This switch is used for maintenance purposes.
For normal operations, select the "NORMAL" position.
LCD CONTRAST adjustment screw
This is used to adjust the contrast of the LCD display.
SERVICE
NORMAL
TALLY / GPI
IN1], [12V
29
LCD CONTRAST
MAINFRAME
IN2] (DC 12 V, 0.8 A)
12V IN 1
12V IN 2
POWER
ON
OFF
SIGNAL
GND