Positioner Area - Panasonic AV-HS450N Operating Instructions Manual

2. Functions in each area

Positioner area

2-1-6.
 Positioner [X/Y]
These are used when performing the settings below.
 PinP1, PinP2 position settings
 Wipe start position setting (WIPE #5, WIPE #11, SQ #5)
 Camera control
 Flying key position setting
 Chroma key marker position setting
In each case, the settings take effect only when the following menu items have been selected.
Note
The center values of the positioner are set during the time it takes for the unit to start up after its power is
turned on. Do not operate the positioner until after the switcher has started up.
 Rotary encoder [Z]
This is used to set the PinP size, flying key size or to select the chroma key area.
In each case, the settings take effect only when the following menu items have been selected.
PinP1, PinP2 Position adjustments
Rotation angle
adjustments
(X-direction and
Y-direction rotation)
WIPE (BKGD) Start position
adjustments
WIPE (KEY) Start position
adjustments
Chroma key Selection position
adjustments
Flying key Position adjustments
Camera control X: Pan control or focus
Y: Tilt control or zoom
Positioner
X/Y
Size adjustments
(size increased by rotating
the encoder clockwise
and reduced by rotating it
counterclockwise)
Rotation angle
adjustments
(Z-direction rotation)
—
—
Selected area size
adjustments
(size increased by rotating
the encoder clockwise
and reduced by rotating it
counterclockwise)
Size adjustments
(size increased by rotating
the encoder clockwise
and reduced by rotating it
counterclockwise)
control
control
Rotary encoder
Z Switch
Hold switch down to
restore initial values
(X/Y, Z).
Hold switch down to
restore initial values
(X/Y, Z).
Hold switch down to
restore initial values
(X/Y).
Hold switch down to
restore initial values
(X/Y).
Execute sampling
Hold switch down to
restore initial values
(X/Y, Z).
— Switching between
pan/tilt control and
zoom/focus control
27

Z

POSITIONER
Valid menu
All PinP1 and PinP2
menus (except for
PinP1, PinP2/Rotation)
PinP1, PinP2/
Rotation
BKGD/WIPEPos
BKGD/SQPos
KEY/WIPEPos
KEY/SQPos
CHR KEY/Sample1
CHR KEY/Sample2
KEY/FlyKEY
All menus other than
those listed above