Rear Panel Connections Area - Panasonic AV-HS400AE Operating Instructions Manual

1. Functions in each area

1-9. Rear panel connections area

SLOT
 2
SLOT

1
2
R SDI signal input connectors [SDI INPUTS 1 to 4]
IN: SDI signal input
OUT: active through output (Use this as a monitor output application.)
S Optional input connector SLOT1 [INPUTS 5, 6] (optional)
T Optional input connector SLOT2 [INPUTS 7, 8] (optional)
A board (with built-in up-converter), whether an SDI input board, analogue input board, DVI input board or
analogue composite input board, can be connected to each of these slots.
For further details, refer to the operating instructions of the optional board concerned.
U SDI signal output connectors [SDI OUTPUTS PGM, 1, 2]
PGM: PGM output connectors
1, 2: The signals for these connectors can be assigned using a menu.
V Optional output connector SLOT1 [OUTPUTS 3, 4] (optional)
W Optional output connector SLOT2 [OUTPUTS 5, 6] (optional)
A board, whether an analogue output board, DVI/analogue output board or SDI output board (with built-in
down-converter), can be connected to each of these slots.
For further details, refer to the operating instructions of the optional board concerned.
X Reference input connector/BB output
connector [REF]
Loop-through output in the external sync mode.
If the loop-through output is not going to be used,
provide a 7-ohm termination.
BB signals output from both connectors in the internal
sync mode.
OUTPUTS
SLOT2 6 5
SLOT1 4 3
DVI/ANALOG OUTPUTS
Y Pb Pr DVI-I
ANALOG OUTPUTS
Y Pb Pr Y Pb Pr
SDI OUTPUTS SDI INPUTS
PGM 4 3
1 OUT IN OUT IN
 
 
INPUTS
8 7 SLOT2
6 5 SLOT1
DVI INPUTS
DVI-I DVI-I
ANALOG INPUTS
Y Pb Y Pb
Pr Pr
LAN RS-422
2 1
OUT IN OUT IN
 
<In the external synchronization mode>
REF
Input the external synchronization signal to the upper of
the two connectors shown above.
18

POWER
SLOT
2
～IN
SLOT
1
REF
TALLY GPI SIGNAL
GND
   
External synchronization signal input
Loop-through output
ON
OFF
