2. Functions in each area
2-1-8. Rear panel connections area
( TALLY/GPI input/output connector [TALLY/GPI] (D-sub 25-pin, female, inch screw)
For details on how to connect this connector, refer to "6. External interfaces".
(Operating Instructions in CD-ROM)
) MAINFRAME connector [MAINFRAME] (RJ-45) (100 Base-TX)
Connect this to the mainframe using the supplied CAT5E cable (STP, straight, 10 m (32.8 ft.)).
* DC power input sockets [12V
Connect the supplied AC adapters (for the control panel) to these sockets.
+ Ground connector [SIGNAL GND]
Connect to the system's earth ground.
, Power switch [POWER]
When the power switch is set to ON, the power indicator ( ) lights and control panel operations may be
performed.
- SERVICE switch [NORMAL/SERVICE]
This switch is used for maintenance purposes.
For normal operations, select the "NORMAL" position.
. LCD CONTRAST adjustment screw
This is used to adjust the contrast of the LCD display.
SERVICE
NORMAL
TALLY / GPI
(
-
IN1], [12V
27
LCD CONTRAST
MAINFRAME
)
.
IN2] (DC 12 V, 0.8 A)
12V IN 1 12V IN 2
POWER
ON
SIGNAL
GND
*
+
,