Emerson unidrive sp User Manual page 79

Safety Mechanical Basic Running SMARTCARD Onboard Advanced Technical UL Listing
Product Electrical Getting
Optimization Diagnostics
Information information Installation Installation Started parameters the motor operation PLC parameters Data Information
Modbus RTU
When the Modbus RTU protocol is used addresses between 0 and 247
are permitted. Address 0 is used to globally address all slaves, and so
this address should not be set in this parameter
ANSI
When the ANSI protocol is used the first digit is the group and the
second digit is the address within a group. The maximum permitted
group number is 9 and the maximum permitted address within a group is
9. Therefore, Pr 0.37 is limited to 99 in this mode. The value 00 is used
to globally address all slaves on the system, and x0 is used to address
all slaves of group x, therefore these addresses should not be set in this
parameter.
79
Unidrive SP Free Standing User Guide
Issue Number: 1 www.controltechniques.com