Foot Control; Messages And Beeps; Typical Warning Messages - VERITAS 9000A5 Operating Instructions Manual

Commissioning

Foot control

Only connect the foot control when the device is switched off.
Avec la pédale de commande, la vitesse de couture peut être réglée de manière continue.
The foot control is used for stepless regulation of the sewing speed. The firmer this is pressed,
the quicker the machine runs.
Insert the plug into the mains supply socket (220-240V).
Switch the sewing machine on and then press the foot control slowly to start sewing.
Take your foot off the foot control to make the sewing machine stop again.
Note:
− Only the original foot control may be used.
Messages and acoustic tones
− For fault-free operation: 1 beep
− For malfunctions: three short beeps
− For malfunctions of the sewing machine and if the machine does not sew: 8 second long short beeping.
This means that the thread is twisted, caught and the handwheel axle cannot turn. Please see page 55
„Troubleshooting" on how to rectify this problem. Once the problem has been solved, the sewing
machine will continue sewing.
Note:
− If the problem continues, contact the customer service
Caution:
− If the thread gets caught in the hook and the needle cannot move, release the foot pedal immediately.
If the foot control continues to be pressed, a protection function will stop the sewing machine.
When the main power switch is switched off («O» =off) and switched on again («I» =on), the machine
is operational again.

Typical warning messages:

1. Holder for bobbin in winding position
– As soon as the holder for the bobbin is pressed to the right into the «winding position», the
will appear in the LCD screen. In this position, it is only possible to wind up one bobbin thread spool
(see also page 11). The transport and input of a stitch is refused and accompanied by beeping
– Swing the holder back to the left into the sewing position (the
2. Pull the buttonhole lever down (page 34 and 37)
– The symbol appears in the display for the buttonhole stitches «17 - 27» and for the darning stitch «29».
This indicates that the buttonhole lever needs to be pulled down as otherwise the transport will not
function properly
– After use, push the buttonhole lever back up again
Veritas 9000A5
-symbol
-symbol disappears)
8