Table of Contents
Advertisement
Threading the upper thread
1.
Start by raising the needle to its highest point.
2.
Continue turning the handwheel counterclockwise until the needle just slightly begins to
descend. Raise the presser foot to release the tension discs.
3.
Place the spool of thread on the spool pin so that the thread comes from the front of the
spool, then place the spool cap at the end of the spool pin.
4.
Draw thread from spool through the upper thread guide and pulling thread through pre
tension spring as illustrated. (3/4)
5.
Thread tension module by leading thread down right channel and up left channel. During
this process it is helpful to hold the thread between the spool and thread guide.
6.
At the top of this movement pass thread from right to left through the slotted eye of the
take up lever and then downwards again.
7.
Now pass thread behind the thin wire needle clamp guide and then down to the needle
which should be threaded from front to back.
8.
Pull about 15 cm. of thread to the rear beyond the needle eye. Trim thread to length with
built in thread cutter.
Two-step presser foot lifter
1. The presser foot lifter raises and
lowers your presser foot.
2. When sewing several layers or
thick fabrics, the presser foot can
be raised a second stage for easy
positioning of the work.
Please Note:
The needle must always be at the
highest position.
15
Advertisement
Table of Contents
