Threading The Upper Thread - VERITAS 9000A5 Operating Instructions Manual

Veritas 9000A5
Commissioning
13

Threading the upper thread

Threading the upper thread
Note: It is important to thread correctly to prevent sewing problems.
1. Lift up the spool pin. Place the spool of thread on the spool pin so that the thread comes from the front
of the spool, then place the spool cap at the end of the spool pin.
2. Pull the thread from the spool through the upper thread guide.
3. Guide the thread around the thread guide pulling the thread through the pre-tension spring as illustrated.
4. Pull the thread down between the silver-coloured tension discs.
5. Then, down and around the check spring holder.
6. Once at the top, pull the thread from right to the left through the slotted
eye of the take-up lever and then down again.
7. Pass the thread behind the flat, horizontal thread guide.
8. Guide the thread behind the needle clamp guide then thread the end of the thread through the needle
from front to back, and pull out about 10 cm of thread toward the back