Removing The Pci Adapters - IBM N7800 Hardware And Service Manual

Figure 31. Removing the PCI adapters
2. Loosen the thumbscrew on the secondary PCI retaining bracket, located at the
3. Remove any retaining screws from the PCI adapters and set the screw aside.
4. Remove the selected PCI adapter by grasping it by the upper corners of the
5. Repeat the above steps as needed.
Moving the DIMMs to the new motherboard tray
You must remove the DIMMs from the motherboard tray, being careful to note
their location so you reinstall them in the correct sockets in the new motherboard
tray.
About this task
Have the new motherboard tray ready so you can move the DIMMs directly from
the old motherboard tray to the corresponding slots in the new one.
Procedure
1. Locate the DIMMs.
88
IBM System Storage: N7000 Series Hardware and Service Guide
1
2
3
back of the motherboard tray, and then lift the retaining bracket up and off the
chassis frame.
adapter, and gently rocking it out of the socket. Set it on a stable, antistatic
surface. Make a note of which slot the adapter was in. You need this
information when reinstalling the PCI adapters in the new motherboard tray.
3
2
1
PCI card
Retaining bracket
Retaining bracket