IBM N7800 Hardware And Service Manual page 80

12. At the LOADER prompt, enter the following command:
13. Select the Install new software first option from the displayed menu. This
14. The next step depends on which version of Data ONTAP is installed on your
If your system is running...
Data ONTAP 8.0
54
IBM System Storage: N7000 Series Hardware and Service Guide
If you...
Have DHCP enabled
Do not have DHCP enabled
netboot http://path_to_the_web-accessible_directory/netboot/kernel
The system begins to boot, but stops at the Boot menu.
menu option downloads and installs the new Data ONTAP image to the
CompactFlash card. If you are prompted to continue the procedure, enter y
when prompted.
system:
Then...
Reboot the node by entering y when you see the following prompt:
The node must be rebooted to start using the newly installed
software. Do you want to reboot now? [y/n} y
The controller module reboots, but stops at the Boot menu because the
CompactFlash card was reformatted and the configuration data needs to be
restored.
Then...
Enter the following command:
ifconfig e0a -auto
Enter the following command:
ifconfig e0a -addr=filer_addr
-mask=netmask -gw=gateway -dns=dns_addr
-domain=dns_domain
filer_addr is the IP address of the storage
system.
netmask is the network mask of the storage
system.
gateway is the gateway for the storage
system.
dns_addr is the IP address of a name server
on your network.
dns_domain is the Domain Name System
(DNS) domain name. If you use this
optional parameter, you do not need a fully
qualified domain name in the netboot server
URL; you need only the server's host name.
Note: To netboot the node when your
system is running in 7-Mode, use an IP
address that is not the management IP
address for the target.
Note: Other parameters might be necessary
for your interface. For details, use the help
ifconfig command at the LOADER prompt.