Table of Contents
Advertisement
Attention: You must perform a clean system shutdown before replacing
system components to avoid losing unwritten data in the NVRAM. The
NVRAM adapter has a red LED that blinks if there is unwritten data in the
NVRAM. If this LED is flashing red after you enter the halt local command,
reboot your system and try halting it again.
2. If you are not already grounded, properly ground yourself.
3. Turn off the power supplies and unplug both power cords from the power
source:
If your system uses...
AC power
DC power
Saving the Fibre Channel configuration for HA pairs in SAN
configurations
If you have a SAN configuration and the system is in an HA pair, you must save
the onboard Fibre Channel port configuration information before replacing the
motherboard tray, so you can re-enter it on the new motherboard tray.
Procedure
1. Enter the following command from the partner node to save the onboard Fibre
Channel port configuration information for the target node (the system on
which you are replacing the motherboard tray): partner fcadmin config
2. Copy and save the screen display to a safe location for the steps later in this
procedure.
Removing the motherboard tray and components
You must remove the old motherboard tray from the chassis and move all
field-replaceable components to the new motherboard tray.
Opening the system
To access components inside the controller, you must open the system.
Procedure
1. If you are not already grounded, properly ground yourself.
2. Unplug the system cables from the motherboard tray, as needed, and keep
track of where the cables were connected. Leave the cables in the cable clips
of the cable management tray so that when you reinstall the cable
management tray, the cables are already aligned.
3. Remove the media converters from the NVRAM6 adapters, and set them
aside.
4. Grasp the cable management tray by the side, gently push on the sides of the
tray to unhook it, and then pull the tray off the back of the motherboard tray
and set it aside.
Then...
Unplug the power cords from the power
source, and then remove the power cords.
Remove the power at the DC source, and
then remove the DC wires, if necessary.
Chapter 5. Replacing N7000 series system devices
85
Advertisement
Table of Contents
