If your system uses...
DC power
Removing the Fibre Channel tray
You must use this procedure to remove the Fibre Channel tray from the system.
Procedure
1. Remove the cable management tray by gently pushing the sides of the tray at
the arrows and lifting the tray up.
Figure 36. Removing the cable management tray
1
2. Loosen the thumbscrews on both ends of the Fibre Channel tray, and then
swing the thumbscrew retainer bars away from the Fibre Channel tray.
1
2
Figure 37. Removing the Fibre Channel tray
Then...
Remove the power at the DC source, and
then remove the DC wires, if necessary.
1
Cable management tray
Chapter 5. Replacing N7000 series system devices
133