7. Enter the following command to boot the operating system:
boot_ontap
Restoring Fibre Channel configurations
Because the onboard Fibre Channel (FC) ports are not preconfigured, you must
restore any FC port configurations in your HA pair before you bring the node back
into service; otherwise, you might experience a disruption in service. Systems
without FC configurations can skip this procedure.
Before you begin
You must have the values of the FC port settings that you saved earlier.
Procedure
1. From the healthy node, verify the values of the FC configuration on the
replacement node by entering the applicable command:
system node run -node partner-node-name fcadmin config
2. Compare the default FC variable settings with the list you saved earlier.
If the FC variables are...
The same as you recorded earlier
Then...
Proceed to the next step in this procedure.
Chapter 5. Replacing N7000 series system devices
125