Replacing A Compactflash Card In N7000 Series Systems Running Data Ontap; N7000 Series System Components - Rear (Exploded View) - IBM N7800 Hardware And Service Manual

Fibre Channel tray
Figure 13. N7000 series system components - Rear (exploded view)
Replacing a CompactFlash card in N7000 series systems running Data
ONTAP 7.x
Note: This section contains procedures for two different Data ONTAP 7.x
configurations. You must use the correct procedure for your configuration:
v If you have a single-controller configuration, see "Replacing a CompactFlash
v If you have an active/active or high availability configuration, see "Replacing a
You might also need the following documentation to perform the identified
procedures. Data ONTAP documents are available on the IBM N series support
website, which is accessed and navigated as described in "Websites" on page xx.
v IBM System Storage N series Data ONTAP Upgrade Guide, as applicable
v IBM System Storage N series Data ONTAP Commands: Manual Page Reference, if
v IBM System Storage N series Data ONTAP System Administration Guide, if
These procedures are written with the assumption that you have access to at least
one of the following:
v A system on your network that you can use to netboot your system.
v A PC with a card reader/writer and with access to the IBM N series support
PCI expansion
adapters
DIMMs
6 motherboad tray
thumscrews
card in a single-controller system running Data ONTAP 7.x" on page 32.
CompactFlash card in an active/active configuration running Data ONTAP 7.x"
on page 35.
applicable
applicable
website.
RTC
battery
Cam handle
Chapter 5. Replacing N7000 series system devices
2 power supplies
DIMMs
2 retaining
latches
31