IBM N7800 Hardware And Service Manual page 34

Table 8. Installation process procedures (continued)
Stage Procedure
2 IBM Service will
install the N7000
series system in a
freestanding rack, if
required.
3 Connect the N7000
series system to the
customer-provided
IP (Internet
Protocol) network.
4 Filer: Connect the
N7000 filer system
to storage
expansion units.
Gateway: Connect
the N7000 gateway
system to the
back-end storage.
5 Connect the N7000
series system to a
power source.
6 Configure the
system.
7 Connect the N7000
series system to a
third-party device.
8
IBM System Storage: N7000 Series Hardware and Service Guide
Is the
Procedure is performed by...
procedure
required? Filer
Yes IBM
Yes IBM
Yes IBM
Yes n/a
Yes IBM
Yes IBM
No Customer
Gateway For instructions, see...
IBM The Installation and Setup
Instructions that came with your
system
Customer "Connecting your N7000 series
system to an IP network" on page
9, or the Installation and Setup
Instructions that came with your
system
n/a "Connecting a filer to storage
expansion units" on page 10, or the
Installation and Setup Instructions
that came with your system
Customer The Data ONTAP Gateway
Implementation Guide for your
back-end storage and version of
Data ONTAP
Customer "Connecting your N7000 series
system to a power source" on page
10, or the Installation and Setup
Instructions that came with your
system
Customer The Data ONTAP Software Setup
Guide for your version of Data
ONTAP, or the Installation and
Setup Instructions that came with
your system
Customer "Connecting your N7000 series
system to storage" on page 10