Removing The Rlm; Installing The Rlm; Removing The Rlm Carrier - IBM N7800 Hardware And Service Manual

Removing the RLM

To remove the RLM from the system, you must perform a specific sequence of
steps.
Procedure
1. Remove the bezel and locate the RLM directly under the CompactFlash carrier
2. Loosen the thumbscrew on the left side of the RLM carrier, and then swing the
Figure 16. Removing the RLM carrier
3. Slide the RLM out of the carrier and set it aside.

Installing the RLM

You must complete a specific set of steps to install the RLM in the system.
Procedure
1. Align the replacement RLM with the carrier, gently slide it into the system
2. Reinstall the bezel.
60
IBM System Storage: N7000 Series Hardware and Service Guide
If your system uses...
AC power
DC power
on the LCD module on the front of the chassis.
retaining arm to the right.
1
Thumbscrew
1
Retaining bar
2
making sure that it is seated completely, and then swing the locking arm to the
left and tighten the thumbscrew.
Then...
Unplug the power cords from the power
source, and then remove the power cords.
Remove the power at the DC source, and
then remove the DC wires, if necessary.
2