GCC Technologies puma iii series User Manual page 15

Step 5
Insert the roll holder support with the screws into the holes of the stand, and then
tighten them up as shown in
position by inserting into different holes.
Figure 2-4
Step 6
Place two roll holders onto the roll holder support and ensure the white protrusion
is wedged in the groove. (
Roll holders
Installation
. You could decide roll holder support's
Figure 2-4
)
Figure 2-5
Figure 2-5
2-4
Puma III User Manual
4 screws
Roll holder
support
Roll holder support