Connecting Your Gcc Cutter; Installing The Software - GCC Technologies puma iii series User Manual

Use the USB One-click Installation for quick driver installation. Follow the
simple steps below for driver setup.
Step 1:

Connecting your GCC cutter

1. Turn on the machine.
2. Connect the USB connector to the machine and then USB driver will
installed automatically. It will take a few minutes to find the device.
Please DO NOT disconnect the USB cable until the installation has
completed.
3. You can double click the USB icon on the taskbar to make sure the USB
device is detected.
Step 2: Installing the software
(1) Put the installation CD into your CD-ROM.
USB device is connected before you start the driver installation.
(2) Choose the model you want to install from the driver list and click on Win
8/ 7/ Vista/ XP Driver (Manual Selection) or Win 8/ 7/ Vista/ XP Driver
(Automatic detection) to start installing the Driver and AAS plugin. (The
Expert Pro model is used as an illustration in the following steps.)
Installation
Please make sure that the
2-10
Puma III User Manual