Table of Contents
Advertisement
parameters includes Speed, Force, Offset, Up Speed, Quality
and Scaling though the latter three will not be displayed in this
section. To adjust or check individual parameters, go back to
the responding keys on the panel and press "Enter" to
confirm.
Set Smoothing
To enable smooth-cutting function.
Cut
Over Cut
To generate an overcut to facilitate weeding.
Set Tangential
To enable the emulated tangential-cutting mode for thicker
Mode
media types and small letter cuts.
Note: while the Offset value setting at 0.000 mm, "Set
Tangential Mode" will automatically be disabled.
Panel Setup
Accept setup command:
To accept commands of the Force, Speed, Cutting Quality,
and Offset only via software.
Control panel only:
To accept commands of the Force, Speed, Cutting Quality,
and Offset only via control panel of the cutter.
Restore
To turn all parameters of the menu items to factory-default
Default
settings.
Auto Unrolled
To avoid paper jam and motor crash by automatically unroll
Media
media (50cm and up) before cutting while enabled. .
* Auto-unroll only effects on roll/edge media.
* Using Single mode to size media will disable this function
automatically.
* If the length of the rolled media is less than 2 meters or the
weight is light, it is recommended to set this mode disabled.
Rear Paper
To detect if the rear paper sensor is covered to determine the
Sensor
following process; when it is enabled, the cutter will detect if
the material has covered the rear paper sensor under the Roll
and Edge mode; when disabled, the rear paper sensor will
not be functioning.
Note: Rear paper sensor only functions under "Roll" and
"Edge" mode.
Vacuum
To help improve tracking and cutting accuracy by turning on
the fans. If you turn off the vacuum system, the fans
will remain inactive during cutting or plotting.
First Back to
To enable the carriage back to the previous origin; when
Origin
"Enable" is selected, the carriage will not go back to the
previous origin while the selection of "Disable" allows the
carriage to do so.
AAS Offset
To set or modify AAS offset value.
You can refer to "5.3 Printer Test" for more details.
Paper Saving
To save media by four different modes:
Mode
1. Length expanded mode
3. Both expanded mode
Set
To build up the communication between host computer and
cutter.
Communication
Baud Rate is to determine the speed of data transmission.
Data Bits refers to the size of one block of data.
Parity is used to check if data was revived correctly or not.
9600, n, 7, 1, p
9600, o, 7, 1, p
The Control Panel
[ MISC ]
2. Width expanded mode
4. Both unexpanded mode
9600pbs, 7 Bits with NO Parity
9600pbs, 7 Bits with ODD Parity
3-7
Puma III User Manual
Enable
0.00mm-1.00mm
0.00mm
0.05mm/per step
Disable
Enable
Enable
Enable
Disable
Enable
Enable
Enable
Disable
Length
expanded
mode
Advertisement
Table of Contents
