Enable The Cropmarks - GCC Technologies puma iii series User Manual

3. Enable the cropmarks.

Next, you need to make a choice which system that you want to use, there are three different
systems:
GCC AASII
GCC AASII, Multicopy
GCC AASII, Multisegment
The size of the cropmarks is fixed at 25 mm. Just click "OK" to close the dialog. If you have
chosen the "Multicopy" cropmarks, there will be extra settings for horizontal copies, vertical
copies etc, please ignore these for now, we will get back to them later.
EasySIGN Instruction
Right-click on an empty part of the worksheet, and
choose the command "Cropmark settings".
This will show a dialog.
Please tick the box called "Show Print & cut cropmarks".
This system uses four cropmarks, and one copy. It is meant for
jobs that are not very large (like 60 cm or smaller) and that are
going to be printed on single sheets.
Use this system when you want to cut multiple copies of a small
job. This will give you very high accuracy, but the plotter will
scan every copy of the job separately, which is of course slower
than one big job.
Use this system when the job is large. We recommend it for
jobs bigger than 60 centimeter. It will place extra markers on the
sheet, which will enhance the accuracy but will take extra time
to scan.
A-5
Puma III User Manual