Menu In Off-Line Mode - GCC Technologies puma iii series User Manual

3.3

Menu in Off-line Mode

Press [ON/OFF LINE] to switch to the offline mode
Offline For
System Setup
[ FORCE]
[ OFFSET ]
[ DATA CLEAR ]
[ ]
[ SPEED ]
[CUT TEST ]
Square Cut
Select:
Repeat AAS Job
Select:
Repeat Last Plot
Select:
Pattern Setting
Select:
Ratio Setting
Select:
Blade Length Adjust
Select:
The Control Panel
Force: 80 gf
OK:ENTER
Offset: 0.275 mm
OK:ENTER
Clear Data Memory
N:Cancel OK:ENTER
move origin
X: Y:
Speed: 51 cm/s
Select: OK:ENTER
UP Speed: 51 cm/s
Select: OK:ENTER
Quality: Fine
Select: OK:ENTER
OK:ENTER
OK:ENTER
OK:ENTER
OK:ENTER
OK:ENTER
OK:ENTER
5~400 with an increment of 5(gram force)
0.000~1.000 with an increment of 0.025(mm)
Speed:3~60 with an increment of 3(cm/s)
:3~60 with an increment of 3(cm/s)
UP Speed
Draft, Normal, Fair, Fine
Pattern: Arrow
Change: OK: ENTER
Ratio: 100%
Change: OK: ENTER
Set Length 0.00mm
Change: OK: ENTER
3-3
Puma III User Manual
Pattern: Cross, Arrow
Ratio: 100%, 200%, 300%, 400%
Test Blade Holder
OK: ENTER
Test Blade Length
OK: ENTER
Turn CW , Turn CCW