Basic Operations Using The Remote Control - Panasonic PT-D10000E Operating Instructions Manual

Basic operations using the remote control

INPUT
SELECT
ON
SCREEN
TEST
PATTERN
STATUS
LIGHT
Using the SHUTTER
function
If the projector is not used for a certain period of
time during the meeting intermission, for example, a
shutter mode is available that allows the user to hide
images temporarily.
1. Press SHUTTER on the remote
control or the main unit.
• The image is turned off.
. Press SHUTTER again.
• The image comes back.
On-screen display
function
This turns the on-screen display function on and off.
1. Press ON SCREEN on the
remote control.
Switching the input signal
You can use the remote control to switch the signals
that are being input and projected.
AUTO
SETUP
1. Press INPUT SELECT on the
remote control or the main unit.
• Press RGB1:
SHUTTER
Switches to RGB1 input.
• Press RGB:
Switches to RGB2 input.
• Press DVI-D:
ASPECT Switches to DVI-D input.
• Press VIDEO:
Switches to video input.
FUNC1
• Press S-VIDEO:
Switches to S-VIDEO input.
• Press AUX:
Switches to optional input module input.
(The AUX button to switch the input is
disabled when an optional input module is not
connected.)
Note
• Refer to "Connection" for details on the input
terminals. (pp. 25, 26)
Status function
This shows the projector status. It can also be used
to send information about the projector's status via
e-mail.
1. Press STATUS on the remote
control.
STATUS STATUS
INPUT : RGB1 INPUT : RGB1
PROJECTOR RUNTIME : PROJECTOR RUNTIME :
LAMP1 : LAMP1 :
LAMP2 : 10h/OFF/ LAMP2 : 10h/OFF/
LAMP3 : LAMP3 :
LAMP4 : LAMP4 :
TEMP TEMP
VERSION MAIN VERSION MAIN
VERSION NETWORK : 0.09 VERSION NETWORK : 0.09
REMOTE2 : DISABLE REMOTE2 : DISABLE
ENTER ENTER
Note
• Refer to "How to use network function" for details.
(pp. 84-97)
: 0.00kHz/ 0.00Hz : 0.00kHz/ 0.00Hz
13h 13h
9h/OFF/ 9h/OFF/
9h/OFF/ 9h/OFF/
9h/ON/ 9h/ON/
: IN- 27 / OUT- 32 /OPT- 36 : IN- 27 / OUT- 32 /OPT- 36
: 0.55 : 0.55
END STATUS VIA E-MAIL END STATUS VIA E-MAIL
4
ENGLISH –