Panasonic PT-D10000E Operating Instructions Manual page 58

Adjusting the position (continued)
Adjusting the zoom ratio
This adjusts the size of the projected pictures.
1. Press ▲▼ to select "ZOOM".
POSITION POSITION
SHIFT SHIFT
ASPECT ASPECT
ZOOM ZOOM
CLOCK PHASE CLOCK PHASE
KEYSTONE KEYSTONE
MENU SELECT MENU SELECT
SUB MENU SUB MENU
ENTER ENTER
. Press ENTER.
• The "ZOOM" screen will be displayed.
ZOOM ZOOM
MODE MODE
INTERLOCKED INTERLOCKED
V V
H H
HV HV
MENU SELECT MENU SELECT
CHANGE CHANGE
3. Press ▲▼ to select "MODE".
4. Press ◄► to switch "MODE".
• The setting will change as follows each time
◄► is pressed.
INTERNAL INTERNAL
INTERNAL:
•
Enlarges the size of the pictures to within the
default aspect ratio.
• FULL:
Enlarges the pictures using the whole of the
display area.
5. Press ▲▼ to select
"INTERLOCKED".
ZOOM ZOOM
MODE MODE
INTERLOCKED INTERLOCKED
V V
H H
HV HV
MENU SELECT MENU SELECT
CHANGE CHANGE
58
– ENGLISH
DEFAULT DEFAULT
0 0
INTERNAL INTERNAL
OFF OFF
100% 100%
100% 100%
100% 100%
FULL FULL
INTERNAL INTERNAL
OFF OFF
100% 100%
100% 100%
100% 100%
6. Press ◄► to switch
"INTERLOCKED".
• The setting will change as follows each time
◄► is pressed.
OFF OFF
• OFF :
The "V" and "H" settings are used as the vertical
and horizontal zoom ratios respectively.
• ON :
The zoom ratio is set to the "HV" setting. This
allows the pictures to be zoomed at equal
vertical and horizontal ratios.
Note
• When "ASPECT" is set to "THROUGH", "ZOOM" will
not appear.
Clock phase adjustment
Clock phase adjustment achieves the best image
when the screen flickers or halo is observed around
the contour.
1. Press ▲▼ to select "CLOCK
PHASE".
POSITION POSITION
SHIFT SHIFT
ASPECT ASPECT
ZOOM ZOOM
CLOCK PHASE CLOCK PHASE
0 0
KEYSTONE KEYSTONE
MENU SELECT MENU SELECT
ADJUST ADJUST
2. Press ◄► to adjust the level.
• The value changes from 0 to 31. Adjust so that
the amount of interference is at a minimum.
Note
• No optimal value may be obtained if the output
of the PC to which the signal input is applied is
unstable.
• No optimal value may be obtained if the total
number of dots is not correct.
• The clock phase can be adjusted only when RGB
signal input is applied with RGB1 and RGB2 IN.
ON ON
DEFAULT DEFAULT