Projection; Terminal Of The Projector - Panasonic PT-D10000E Operating Instructions Manual

Projection

Power indicator lamp
This shows the power supply status. Make sure
that you fully understand the operation of the power
FILTER
CLEANING
indicator lamp before operating the projector.
Indicator Indicator
status status
Off Off
Red Red Lit Lit
Green Green Lit Lit
Orange Orange Lit Lit
Attention
• While the projector is in standby preparation mode
(when the power indicator lamp is lit orange), the
internal fan is running to cool down the projector. Do
not turn off the MAIN POWER switch or disconnect
the power cord at this time.
Note
• If the POWER ON " | " button is pressed while the
projector is still in standby preparation mode, it may
take some time before the projector is ready to
project pictures.
• The cooling fan will still be operating and the
projector will still be drawing approximately 25 W of
power while the projector is in standby mode (when
the power indicator lamp is lit red).
4
– ENGLISH
Power indicator lamp
OPEN
FILTER
CLEANING
CLOSE
OPEN
CLOSE
Projector status Projector status
Main power is off Main power is off
Standby mode Standby mode
POWER ON (|) button can be pressed POWER ON (|) button can be pressed
so that images can be projected. so that images can be projected.
Images are being projected (on) Images are being projected (on)
Standby preparation mode Standby preparation mode
After a short while, the projector will After a short while, the projector will
switch to standby mode. switch to standby mode.
Connecting the power
cord
Insert the accessory power cord securely into the
projector and the electrical outlet.
Be sure to read the "IMPORTANT SAFETY NOTICE"
(pp. 4-5) and "Precautions with regard to safety"
(pp. 6-9) for details on handling the power cord.
■
Installation
1. Check the shape of the AC
IN terminal on the side of the
projector and the shape of the
power cord connector, and
insert the power cord securely
into the AC IN terminal.
. Insert the power cord plug into
an electrical outlet.
■
Removal
1. Check that the MAIN POWER
switch on the projector is at
the OFF position, and then
disconnect the power cord plug
from the electrical outlet.
. Disconnect the power cord
connector from the AC IN

terminal of the projector.

Attention
• Connect all peripheral equipment to the projector
before connecting the projector's power cord.
(pp. 25-26)