Before Asking For Service - Panasonic PT-D10000E Operating Instructions Manual

Before asking for service

Symptoms
Power does not turn on
No image appears on screen
Screen image is blurred
Pale colour / bad colour tint
Remote control does not
function
Abnormal image on the
screen
Images from PC are not
projected
Check point
• Is the power cord securely plugged in the receptacle?
• Is the MAIN POWER switch put to the "O" position?
• Is power supply live at the receptacle?
• Is the temperature monitor (TEMP) lamp on the projector front
lighting or blinking?
• Is the lamp monitor (LAMP) lamp on the projector front lighting or
blinking?
• Is the lamp unit cover completely attached?
• Was operation of ID setting made in a correctly way?
• Are all four lamp units installed?
• Is the lens covered with the cap?
• Is the screen image input connected in a correct manner?
• Is the device(s) connected to the projector working normally?
• Is the shutter function used?
• Is the lens in focus?
• Is the projection distance adequate?
• Is the lens dirty?
• Is the projector placed vertical to the screen?
• Are colour strength and colour tint correctly adjusted?
• Is the device(s) connected to the projector adjusted correctly?
• Are dry batteries consumed?
• Is polarity correct in battery setting?
• Are there any obstacle between the remote control and the beam
receiving window?
• Are you trying to operate the remote control beyond the effective
range?
• Is the remote 2 (REMOTE2) terminal used for external control?
• Is any external light interfering with the remote control operation?
• Was operation of ID setting made in a correctly way?
• Is the LOCK button of the remote control at the lock position?
• Is adjustment value protection enabled? Press ▼+ ▼ +
ENTER+ ▼ + ▼ + ENTER to cancel the protection.
• Is the input selector set to correct position?
• Is the correct signaling system selected?
• Are there any malfunctions on the source side, such as bad video
tape?
• Are you supplying a signal that is not compatible with the projector?
• Is the cable too long?
• Is the correct signal destination set for notebook computer screen
image?
• Use and keys for setting. (For details, refer to the instruction
Fn F3
manual of the computer.)
... try to check the following points again.
ENGLISH –
Page
34
35, 36
34
107
107
111
18, 75
109, 110
25
43, 54
-
43
37
21, 22
-
20
50, 51
-
-
17
17
17
106
-
18, 75
11
64
43, 54
54
-
119
-
-
-
11