KYMCO Venox 250 Service Manual page 123

10
.TRANSMISSION SYSTEM
INSTALLATION
The installation sequence is the reverse of
removal.
＊
Transmission fork make is as follows
R(right),C(center),L(left).
TRANSMISSION GEARS REMOVAL
Remove the transmission main shaft and
counter shaft from the upper crankcase.
＊
When removing, the transmission gears
must be removed as a set.
Disassemble the main shaft and counter
shaft.
GEAR/SHAFT COLLAR INSPECTION
Check each gear and gear teeth for wear,
damage, or poor lubrication.
Measure each gear I.D.
Service Limits:
Main shaft 4th gear25.081mm replace if
Main shaft 5th gear25.081mm replace if
Countershaft 1st gear23.081mm replace if
Countershaft 2nd gear28.081mm replace if
Countershaft 3rd gear28.081mm replace if
over
over
over
over
over
Left
Main Shaft
VENOX250/250i
Center Right
Counter Shaft
10-8