Starter Relay; Clutch Diode - KYMCO Venox 250 Service Manual

17
. STARTING SYSTEM

STARTER RELAY

INSPECTION
Turn the ignition switch ON and the starter
relay is normal if you hear a "click" when
the starter button is depressed.
If there is no click sound:
Inspect the starter relay voltage
Inspect the starter relay ground circuit
Check for continuity between the starter
relay yellow/red and green/red wire
terminals
Check if the side stand position is up.
Check if is neutral position. If not,
directly apply the clutch lever and push
the starter switch.
Connect a 12V battery across the starter
relay yellow/red and green/red wire
terminals.
Connect an electric tester between the
starter relay large terminals and check for
continuity between the two terminals.
The relay is normal if there is continuity.
Replace the starter relay with a new one if
there is no continuity.

CLUTCH DIODE

INSPECTION
Check the continuity between the wire
terminals.
Normal Direction: Continuity
Reverse Direction: No Continuity
Starter Relay
Clutch Diode
17-4