Self-Diagnostic Procedures Without Diagnostic Tool - KYMCO Venox 250 Service Manual

19. AFI (AUTOMATIC FUEL INJECTION)
SELF-DIAGNOSTIC
PROCEDURES WITHOUT
DIAGNOSTIC TOOL
＊
Without diagnostics program (D tool 5.0)
can be performed condition.
SELF-DIAGNOSTIC PROCEDURES
STEP-1
"key OFF "→ The throttle should be open and
hold fully
STEP-2
"key ON " →the CELP lamp will light for two
second then off.
Waiting for the CELP lamp again light
The throttle should be close.
The CELP lamp will to start output failure
Signs.( failure codes to use of long、short lamp to
collocate glisten showed)
When more than one failure occurs, the CELP
lamp shows the codes in the order of lowest
number to highest number. For example, if the
indicator blinks once, after code off 4 seconds
and comes on 4 seconds, then blink 2 times, two
failures have occurred. Follow codes 1 and 2.
CLEAR- FAILURE CODES PROCEDURES
STEP-1
You should be failure parts or Sensors to
exclude. .
STEP-2
"key OFF "→ The throttle should be open and
hold fully
STEP-2
"key ON " →the CELP lamp will light for two
second then off.
Waiting for the CELP lamp again light
The throttle should be open and hold
fully.(waiting for 10 seconds↑)
The CELP lamp don't output failure codes.
Finish. Clear failure codes procedures
19-7
VENOX250/250i
CELP LAMP