Mounting Options; Surface And Wall Mounting; Rack Mounting; N2X51 Series Stand-Alone Units - AMX NMX-ENC-N2151 Instruction Manual

N2151/n2251 encoders/decoders 4k digital media distribution & switching solution
Hide thumbs Also See for NMX-ENC-N2151:
Table of Contents

Advertisement

Mounting Options

The N2X51 units are available in stand-alone and card versions. The stand-alone version can be free standing, surface mounted,
wall mounted, or rack mounted. All cards must be rack mounted using the NMX-ACC-N9206 Card Cage (sold separately).

Surface and Wall Mounting

To mount your N2X51 stand-alone unit to a flat surface or wall, follow these steps:
1.
Remove the four screws from the bottom of the unit and use them to attach the mounting wings (sold separately - part
number NMX-ACC-N9101). See
2.
Place the unit against the solid surface to which you want it mounted.
3.
Using standard hardware, attach the unit through each of the slots of the newly-attached mounting wings.
4.
Connect the appropriate cables necessary for your application. Refer to the sections : Connecting Decoders to the Network on
page 14 and : Connecting Encoders to the Network and Conf iguring Stream Settings on page 15 for more information on these
connections.
Installing Mounting Wings
FIG. 5

Rack Mounting

N2X51 Series Stand-Alone Units

The N-Series 1RU Rack Shelf (part number NMX-ACC-N9102) accommodates up to two stand-alone N-Series Encoders or
Decoders, side by side (any combination of product series).
Rack Mounting Stand-Alone Units
FIG. 6

N2X51 Series Cards

The N-Series Card Cage (part number NMX-ACC-N9206) accommodates any combination of up to six N-Series Encoder/Decoder
cards. The NMX-ACC-N9206 card chassis provides 12V connections to all cards (installed as the primary power source).
Use either of the following
requirements of each installed card (e.g., Power_Slot1 = the power requirements for whatever card is installed in the first slot).
These formulas adds a 20% margin to the power requirements of the cards to allow for the chassis cooling fan power consumption
as well as any inherent power supply losses.
Total Power = (Power_Slot1 + Power_Slot2 + Power_Slot3 + Power_Slot4 + Power_Slot5 + Power_Slot6) * 1.2
or
Total BTU/hr = (BTU/hr_Slot1 + BTU/hr_Slot2 + BTU/hr_Slot3 + BTU/hr_Slot4 + BTU/hr_Slot5 + BTU/hr_Slot6) * 1.2
N2151/N2251 User Manual
Figure
5.
formulas to calculate how much power is required for the N9206. Formulas are based on the power
Installing and Configuring Your AV Equipment
10

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nmx-dec-n2251

Table of Contents